Skip to the page
Ask for a free quote
Clark County Holiday Lighting

Christmas Light Installation Cost in Vancouver, WA

Christmas light installation cost in Vancouver, WA comes down to feet of roofline, the height of the house and whose lights go up. Here is what three national cost guides publish, and how to turn it into a number for your own house.

A guide gives a range. Send the house and a Clark County, WA installer gives you the one number that matters.

Ask for a free quote

How much does it cost to pay someone to put up Christmas lights in Vancouver, WA?

HomeAdvisor puts a professional christmas light installation at $220 to $683, with $444 the typical project, for setup and takedown. Fixr gives $250 to $650 with a $450 national average. HomeGuide, which counts bigger jobs, gives $250 to $1,500 for a basic roofline package. None of the three publishes a figure for Vancouver, WA or Clark County, WA alone, so read these as national numbers and check them against a local quote.

Source What it publishes Read
HomeAdvisor, updated 19 June 2026 $220 to $683 a project, $444 typical, setup and takedown; $2.50 to $7 per linear foot; multi-storey homes up to $1,300 12 Nov 2026
Fixr $250 to $650, $450 national average; $2 to $5 per foot for materials and labour 12 Nov 2026
HomeGuide, 1 October 2025 $5 to $12 per linear foot; $250 to $1,500 for a basic roofline package; $750 to $5,000 for a full package 12 Nov 2026

The guides disagree by more than a little, and the reason is what each one counts. HomeAdvisor and Fixr price a typical job, which on most houses means the roofline. HomeGuide's full package adds windows, the garage, shrubs and trees, and its per-foot range is higher across the board. A ranch house with one run of gutter and a few shrubs sits nearer the first two. A two-storey house with wrapped maples sits nearer the third.

The long gutter line of a single-storey ranch house and its garage outlined with multicolour C9 bulbs on a damp, overcast night

How much does it cost per foot to install Christmas lights?

Installers price by the linear foot of roofline because that is what takes the time: carrying the ladder, setting the clips, running the strand. The per-foot rate usually includes labour and, when the installer supplies them, the lights.

Fixr splits its $2 to $5 a foot into $1.50 to $3.50 for labour and $0.50 to $1.50 for the strands. HomeAdvisor puts labour at $2 to $5 a foot and adds $0.50 to $2 a foot when the installer brings the lights. HomeGuide's $5 to $12 a foot is the all-in figure behind its size table.

A per-foot quote is the easiest kind to compare. If two installers quote by the job instead, ask each for the footage they measured and divide.

What changes the price of christmas light installation?

These are what move a quote on houses around Vancouver, WA.

  1. Feet of roofline. A long ranch house with an attached two-car garage can have more gutter than a taller house with a smaller footprint.
  2. Storeys and pitch. A second storey or a steep gable means longer ladders, sometimes a lift, and slower work. HomeAdvisor notes multi-storey homes can reach $1,300.
  3. Whose lights. Your own strings, the installer's strings bought for you, or a rental package where the installer owns them.
  4. What else is lit. Wrapped tree trunks, shrubs, porch rails, windows and a lit path all add lights and labour on top of the roofline.
  5. Power and timers. If the strands need an outlet the house does not have where it is needed, that is extra work. Fixr puts timers at $12 to $50 each.

Bulb type matters less to the labour than people expect. C9 bulbs and mini lights both go up on clips. C9s are the old-fashioned large bulbs and read from the street. Minis cost less a strand and suit shrubs and railings.

How much do people charge to take down Christmas lights?

Most quotes include takedown, and you should ask for it in writing if yours does not. Bought on its own, removal costs:

Source Takedown on its own Read
HomeAdvisor $100 to $400, or roughly $0.50 per linear foot 12 Nov 2026
Fixr $125 to $350 a project, or $0.50 to $0.65 per linear foot 12 Nov 2026
HomeGuide $100 to $400 when the package does not already include it 12 Nov 2026

Storage is the other half. If the installer supplies the lights under a rental package, they usually take them away in January and you store nothing. If you own the lights, ask whether the installer will label and box them by run, which makes next November quicker. None of the three guides puts a separate price on off-season storage, so if you want it, ask for it as its own line on the quote.

How much to install 200 ft of Christmas lights?

Multiply. At HomeAdvisor's $2.50 to $7 a foot, 200 feet comes to $500 to $1,400. At Fixr's $2 to $5, it is $400 to $1,000. HomeGuide's own size table puts 200 feet at $1,000 to $2,400. Two hundred feet is a lot of roofline for a single-storey house; it is closer to a two-storey house with the garage, or a ranch house with the shrubs and a tree added in.

Some installers set a minimum charge for a visit, so a small porch-and-gutter job may not cost much less than a modest roofline. Ask what the minimum is.

Do you buy the lights or rent them with the install?

There are two common arrangements. In the first, you own the lights. You pay for labour each year and keep the strings in the garage between seasons. In the second, the installer supplies the lights, puts them up, keeps them working through December and takes them away in January. HomeAdvisor gives $250 to $600 for a basic rental package, installation and takedown included.

Owning makes sense if you already have good strings and room to store them. Renting suits a house where nobody wants to sort tangled wire in a cold garage, or where the old strings have reached the age when half a run goes dark. Ask what happens if a bulb or a section fails in December under each arrangement. A good quote says whether a service visit is included.

How much does it cost to run Christmas lights each month?

Installation is the bill you see in November. Power is the one that arrives later. HomeAdvisor puts a large incandescent display at $5 to $75 a month to run, and the spread is wide because so much depends on how many strands, what kind, and how many hours a night they burn.

LEDs are the simple way to bring that down. They draw far less than incandescent bulbs of the same size, and HomeAdvisor lists LED strands at $13 to $20 for 25 feet. If an installer supplies the lights, ask which kind they hang. If you are buying your own for an installer to put up, LED C9s keep the old look at a fraction of the running cost.

Hours matter as much as bulbs. A timer that switches the lights off at 11 pm instead of leaving them on until morning cuts the running time by more than half, and in Clark County, WA the lights will have been on since late afternoon anyway.

Two quotes you can actually compare

Prices from two installers only line up if they priced the same job. Before you put them side by side, check that each one names the same runs, the same feet of roofline, whose lights go up, whether takedown is in, and whether a December service visit is included. A quote that looks $150 cheaper and leaves out takedown is not cheaper. Ask each installer the same questions in the same words, and the difference between the numbers will be the difference between the installers.

Measuring your own roofline before you ask

You can get within a few feet from the ground, and it makes every quote easier to compare.

  1. Walk the base of each wall you want lit and count your steps, or run a tape. On a single-storey house, the gutter above is about the same length as the wall below it.
  2. Add the garage separately. Attached garages on 1960s and 1970s ranch houses often carry a long straight run of their own.
  3. For each gable, add the two sloped edges. On a low-pitched roof, each slope is a little longer than half the width of the gable end.
  4. Note the extras: how many trees and how tall, which shrubs, the porch rail, and where the nearest outdoor outlet is.
  5. Write it down as runs, for example "front gutter 62 feet, garage 24 feet, two small gables", and send that with the request.

With those numbers, a quote of $3 a foot or $400 for the job can be checked in seconds.

Reading a quote before you say yes

A clear quote lists the feet it measured, whether the lights are yours or the installer's, what else is lit, whether takedown is included and when it happens, and what a service visit in December costs if a run goes dark. If any of those is missing, ask before you agree.

Washington also has a rule worth knowing. L&I says contractor registration rules under RCW 18.27 may apply when fasteners attach lights to a building, so look the installer up on L&I's Verify tool before work starts. It shows a contractor's registration, bond and insurance. If you are weighing lights that stay up all year instead, the electrical rules are different and are set out on the permanent christmas lights page.

One local detail helps when you plan timers. On 1 December 2026 the sun sets at 4:28 pm in Vancouver, WA, by the US Naval Observatory's tables, so a timer set for dusk will bring the lights on before most people are home from work.

More questions about paying for holiday lights

How much should I pay someone to put up xmas lights?

HomeAdvisor and Fixr both put a typical season, up and down, between about $220 and $683. HomeGuide's basic roofline package runs from $250 to $1,500, and two storeys, trees and a full yard push a job toward its top end. Your own number depends on your feet of roofline, so measure first.

Is it cheaper if I already own the lights?

Usually, if your strings are in good order and fit the clips the installer uses. HomeAdvisor adds $0.50 to $2 a foot when the installer supplies the lights. Old strings with dead sections can cost more in labour than they save.

Do installers charge more for a two-storey house?

Yes. HomeGuide's table runs from $250 to $2,400 for one storey and $500 to $3,600 for two, and Fixr's house-size table rises with each storey too. Height means longer ladders or a lift and slower work.

Does the price include taking the lights down?

Often, but not always. HomeAdvisor's $220 to $683 range is for setup and takedown together. If a quote shows only the install, ask for the takedown line before you agree, and see the permanent christmas lights cost page if you would rather never take them down.

Where can I find Christmas light installation services in Vancouver, WA?

Send the house through the quote request on this site: the storeys, a rough length of roofline and what you want lit. It goes to a local installer in Clark County, WA, who prices it before anything goes up. You decide after you see the number. The christmas light installation in Vancouver, WA page explains how it works.

Your roofline, in a few lines

Four short boxes and a line. Saying no costs nothing.

Which kind of lights?

Sent to one local installer for this quote. How the details are handled